WEG Soft Starter, 3-Phase 230/460 Volts, Up to 16 Amps
Description
- Extend equipment life by decreasing mechanical strain
- Reduce water hammer
- Ideal for use with pumps,
WEG soft starters provide full motor protection by allowing your pump motor to ramp up or down in speed over a period of time. This process can reduce damaging water hammer, and minimize electrical and mechanical wear and strain on motors, couplings and transmission equipment.
All parameters and set-up selections are made via dip switches and potentiometers. Status LEDs alert you to operational status. Starters feature built-in bypass contacts for low heat dissipation during running operations. They also have digital inputs for start/stop and fault reset, relay outputs for run indication and full voltage indication, adjustable acceleration and deceleration ramps, and adjustable pedestal voltage. Mount starters directly or on a DIN rail.
Note: For use with variable torque loads only. 120-VAC control power
Product Information
- Item number
- 21999
- Brand Name
- WEG
- Catalog Page
- 29
- Net weight
- 2.6
- Condition
- New
WEG Soft Starter, 3-Phase 230/460 Volts, Up to 16 Amps
- Item number
- 21999
- Brand Name
- WEG
- Catalog Page
- 29
- Net weight
- 2.6
- Condition
- New
- Extend equipment life by decreasing mechanical strain
- Reduce water hammer
- Ideal for use with pumps,
WEG soft starters provide full motor protection by allowing your pump motor to ramp up or down in speed over a period of time. This process can reduce damaging water hammer, and minimize electrical and mechanical wear and strain on motors, couplings and transmission equipment.
All parameters and set-up selections are made via dip switches and potentiometers. Status LEDs alert you to operational status. Starters feature built-in bypass contacts for low heat dissipation during running operations. They also have digital inputs for start/stop and fault reset, relay outputs for run indication and full voltage indication, adjustable acceleration and deceleration ramps, and adjustable pedestal voltage. Mount starters directly or on a DIN rail.
Note: For use with variable torque loads only. 120-VAC control power